Technical data
Product description
Frames constitute the primary load-bearing components after the scaffold is erected, and comprise two standards (uprights) connected by horizontal bars.
Steel frames of tFRAME |UNICO73 come in the standard system width of 732 mm and four heights, where a 2.0 m high frame is the primary frame, and the other are mostly
used at lower scaffold levels for levelling out in sloped terrain, to match the scaffold structure to the building envelope, and in scaffolds where girders are used, or in various non-standard setups.
Standards of the frame (uprights) are made of tubes with outer diameter of 48.3 mm, 2.7 mm in wall thickness, made of heavy duty S235 (Re > 320 MPa) steel.
There are studs on the top ends, made of tubes with outer diameter of 38 mm, used for the erection of the next level’ s frames vertically.
The bottom bar of the frame (with a pin for the installation of the toeboard) stiffens the structure and provides protection against accidental lifting of the scaffold decking.
The top bar is made of a special U-section and is used for deck mounting. it is supported on both ends by stays, which reinforce the load-bearing structure, but are alsoused for the mounting of one and of the longitudinal
vertical bracing..
The structure of the frame ensures mounting ofguardrails in special pockets with wedge locks.